How to Install Outdoor Porcelain Paving
Three of the most common methods for installing outdoor porcelain tiles are outlined below.
Method 1 - Tile Adhesive onto a Solid Base
This method can be used for patios and driveways. It requires the concrete base to be fully cured and expansion joints will need to be added where necessary. With a solid base, achieving a level surface is simple but remember that falls will need to be added to help rain water drain away. Use a polymer modified cement-based adhesive that is suitable for outdoor use. On a solid base, rectified porcelain paving can be installed with a narrow join for a semi-seamless finish.
Method 2 - Wet Bed onto Prepared Sub-base
Paving installers and landscapers favour this method. However, because the tiles are non-porous, they will not adhere to a traditional wet bed. To make the tile stick, yu will need to either mix an admix into your sand and cement or apply a primer to the underside of the tiles. Be careful if using a primer – remove it from the surface and sides of the tile immediately! Check falls during installation and make adjustments by tapping the tiles with a rubber mallet. Avoid any voids beneath the tiles as this may result in the collection of residual moisture which will have no escape route.
Method 3 - Self-levelling Pedestals on roof terraces and balconies
Adjustable pedestals are perfect for use on balconies and terraces. Each pedestal has a self-levelling head and can be slightly adjusted once the tiles are installed. This is a dry installation method as no adhesives or grouts are required. Joints are left open which allows for easy drainage and simple removal of tiles. Lay the weed membrane directly under the grass. Take it right to the edge of the area and overlap it by at least 100mm.